supply Digital Satellite Finder Meter

FEATURES

• Total software upgrade
• Software stored in Flash memory for later upgrade
• Pre-programmed with most regionally used satellites
• Uses USID
• Signal strength and Bit Error Rate (Picture Quality) displayed simultaneously.
• Easy reading LCD display.
• Back lit display.
• Up to 80 satellites may be programmed.
• Bar-graph for Signal Strength
• Bar-graph for BER (Picture Quality).
• Satellite settings store in non-volatile EPROM
• Short circuit proof on LNB output.
• Internal battery powers the LNB
• Works with all stander, universal, linear (DVB) and circular (DSS) polarity LNBs
• Weight approx less than 2 lbs.
• Size approx: 9.84in W x 4.72in H x 2.36in D (250 x 120 x 60 mm)
• Set satellite's related parameter which includes LNB frequency and working voltage (mode of polarization), satellite downstream frequency, symbol ate, 22K situation etc.
• AZ, EL, and PO self-calculated for providing initial dish set-ups.
• Align dish without IR/D, TV and power.
• In alignment process, once a satellite is found by setting related parameter, we can adjust the dish's orientation and pitching angle according to inside audible tone
• Measure RF signal level, bit error rate, carrier-to-noise rate and current.
• Provides special software that can be used to check local position. AZ, EL, and PO for almost all big cities around the world in alignment process of a certain satellite.
• Plans can be downloaded from a certain website by RS232 port.

• Special power supply adapter: 1 piece
• RF input connector GMHF-L9.5-JK: 1 piece
• Instrument bag: 1 piece
• Operator's manual: 1 piece
• CD-ROM: 1 piece
• Data cable: 1 piece