Sell C102 Direct Mount Dump Pump

1) Pump and cylinder protected in the Raise and Neutral position of the spool
2) Manual shift, factory installed OE air, or add-on air shifts each with full metering capabilities
3) Built-in load check maintains dump body angle and is installed in the cylinder port for superior self-cleaning
4) Direct mount SAE B 4 bolt or twin shafted remote mount with bracket
5) Built-in direct acting relief valve set at factory
6) 100% factory tested
7) Flows of 37 and 46 GPM at 1800 RPM
8) Pressures to 2500 PSI
9) Speeds to 2400 RPM
10) High strength alloy steel gear and shaft set
11) Neutral lock-out safety cap for use with pull-out cable
12) 2 line for intermittent duty or 3 line for continuous duty systems
13) 2 extra long studs for easy installation of pump support bracket on direct mount
14) Pressure balanced wear plates maintain high pump efficiency throughout all operating ranges

We can also manufacture the following model according to Parker/Commercial:
G101/102, P15, P20, P21, P25X, P30, P31, P37X, P50, P51, P75, P76, P315, P330, P350, P360, PGP30, PGP31, PGP50, PGP51, PGP75, PGP76, etc.